We use Cookies to improve your website experience. Learn about our cookie policy.

Accept

Skip to Content
Flexco - Partners in Productivity
Main Content

Flexco Polyurethane Skirting Outlasts Expectations

Flexco Polyurethane Skirting

Industry 

Ports and Terminals 

Application 

Coal Reclaimer Conveyor 

Product 

Flexco Polyurethane Skirting

Objective 

Reduce spillage 
Decrease wear rate of skirting 
Contain product 
Eliminate product build up on conveyor structure 
Eliminate idler failure 

Conveyor Details 

1800mm wide belt running at 6m/sec

Problem: 

The coal port’s existing skirting was failing to keep up with the speed of the belts and tonnages conveyed. The skirting was prone to rips and tears because of the poor quality of the polyurethane. After only a few weeks, the skirting began to wear extremely thin, eventually causing it to deflect from a 90° angle as shown below. Because of the defectiveness of the skirting, the site also had product build up on the idler frames, stringers, and conveyor pathway. 


Existing Skirting

Solution: 

The port agreed to an 8-week trial of Flexco polyurethane skirting and recorded results for a period of 24 weeks. The initial goal was to ensure the skirting could outlast the previous product installed by a leading competitor. The current skirting would last no more than 8 weeks before beginning to tear and become ineffective.


Flexco Polyurethane Skirting on Week 1 of trial

Result: 

At the end of the initial trial period, the skirting showed no signs of wear – apart from the fading of the bright purple colour. The site decided to challenge the product, pushing the trial period out to 24 weeks. At the end of this period, the skirting still showed no signs of ripping, tearing, or deterioration. The skirting was also able to deliver on the initial goals set by site – all spillage was contained and the idler frames, stringers, and pathway were clear of build-up. This allowed the site to save money from not only having to replace the skirting far less often, but also on the labour needed to constantly clean around the conveyor to ensure the safety of all staff. The site also experienced less idler failures due to the lack of build-up.


Flexco Skirting after 24 weeks of service

Product Group

  • Impact Beds and Skirting Systems

Product Line

  • Skirting Systems

Industry

  • Ports and Terminals